Instructions for installation and operation - English
Installation & Use Pares - Marami - Code 10013216 - Edition 2 - 10/2011 – Page 14
Remove the cover from the filter or filters and remove the cartridges from the filter body.
Fill the spa directly via the skimmer in order to facilitate the priming of the pumps.
CAUTION:
Do not fill the spa with water from a water softener. If your water is extremely hard, it is preferable to half fill the
spa with the hard water and then complete the filling process with the softened water.
Fill the spa directly via the skimmer in order to facilitate the priming of the pumps until
the water level covers all the jet spouts, but without reaching the level of the lowest
headrest. Avoid over-filling the spa, as it could overflow when users enter it.
Regularly check the water level and adjust it if necessary.
Start the treatment of the water as soon as the spa is full.
IMPORTANT:
Always fill the spa via the skimmers. The failure to use this method could trap air in one or other of the pumps
preventing the normal circulation of the water. Then remove the hose pipe and put back the two filtration cartridges.
During periods when the spa is not in use, we recommend keeping the cover on it in order to prevent evaporation, heat loss
and pollution.
