Instructions for installation and operation - English
Installation & Use Pares - Marami - Code 10013216 - Edition 2 - 10/2011 – Page 30
It is strictly prohibited to use hydrogen peroxide for the chemical treatment of the spa water. This may result in damage
to the tank itself and all the accessories made of plastic. It is also strictly prohibited to use pure bromine. Ask for advice
from your dealer who will propose solutions based on bromine, chlorine or active oxygen tailored to your spa.
Never put chemicals directly into the spa’s tank. Always pour them or put them into the basket of the skimmer, so as
to prevent any risk of damaging the acrylic tank.
We recommend draining the spa regularly and filling it with « fresh » water; the frequency of this operation may
vary between one and two months depending upon the number of users and the frequency with which they use it.
Limited warranty
The spas in our range are covered by a limited warranty. This only protects the original purchaser of the spa.
See the following document: CONDITIONS OF WARRANTY
Cover
Deformation linked to an overloading of the cover is not guaranteed.
Wood surrounds
The wood used for the surrounds of portable spas is natural mahogany. Wood is a living material and consequently colour
variations in the slats are natural and normal. Wood works as a function of the environment.
Installation and use
This warranty will be null and void for damage resulting from the operation of the spa at a temperature outside the range 1°C to
42°C, the operation of the spa below 230V or above 240V, damage caused by dirty or clogged up filters, damage caused by the use of
water that is chemically imbalanced or with an inappropriate pH. Avoid exposing the spa to direct sunlight when it is empty as this
can cause overheating of the acrylic surface resulting in delamination (peeling) or blistering.
Fault finding guide
Message
Meaning
Solution/Recommendation
No message displayed. The spa is not switched on
The control panel will be de-activated as long as
the spa is not reconnected. The spa settings will
be kept until it is switched on again.
FLC
Heater de-activated. The flow/pressure gauge indicates
the presence of a flow that should not be present.
Contact your dealer
FLO
Heater de-activated. The flow/pressure gauge does not
indicate the presence of a flow that should be present.
Contact your dealer
HOH
Alternate display of temperature of the spa or the time.
Detection of a temperature of ≥55°C. The heater stops
DO NOT GO INTO THE WATER. Remove the cover
from the spa and let the water cool down.
ICE
Antifreeze cycle in operation – Cyclic activation of the
pumps for one minute – the frequency of operation
depends on the temperature
DO NOT GO INTO THE WATER. Allow the
antifreeze programme to continue.
rPF
Temperature of the water is outside the range 0°C – 60°C
Contact your dealer
