Instructions for installation and operation - English
Installation & Use Pares - Marami - Code 10013216 - Edition 2 - 10/2011 – Page
8
Warnings for START-UP
Before starting up the machine, verify the calibration of the electrical protection devices of the motor and that the
protections against electrical and mechanical contacts are correctly positioned and attached.
Be especially careful that no water enters the motor or the electrical parts under voltage.
Avoid all contact, even if accidental, with the moving parts of the machine.
Wait until the machine has stopped completely before handling it in any way.
Before carrying out an electrical or mechanical maintenance task, make sure that the machine has been disconnected from
the mains and that the starting devices are locked.
It is advisable to follow the steps listed below before handling the machine in any way:
1.
Turn off the voltage to the machine.
2.
Lock the starting devices.
3.
Verify that there is no voltage in the circuits, including the auxiliary circuits and the supplementary services.
4.
Wait until the rotor stops completely.
The above list should be considered indicative and not binding for the purposes of safety; specific safety rules may exist in
particular regulations.
Regularly verify:
Ͳ
The correct attachment of the mechanical parts and of the support screws of the machine
Ͳ
The correct position, attachment and condition of the supply cables and of the insulating parts.
Ͳ
The temperature of the machine and of the electric motor. In event of any irregularity, stop the machine immediately
and have, it repaired.
Ͳ
The mechanical sound of the machine. In the case of any irregularity, stop the machine immediately and have it
repaired.
Ͳ
The vibrations of the machine. In the case of any irregularity, stop the machine immediately and have it repaired.
2.4
Connection of your SpaPack (hydraulic & electric)
WARNING:
To connect your Spapack, you must:
Ͳ
Put the SpaPack on a flat surface.
Ͳ
Use pipe of 2’’ diamater.
Ͳ
Not exceed 3,5 meter.
Water
circulation
from the spa
Water
circulation
to the spa
Waste
Pump connexion
2’’ diameter
Selector valve