Mainboard KI690-AM2
12
Connectors
Hard Disk Drive Connector: IDE1
The mainboard provides one IDE connector that supports Ultra ATA 133/ 100/ 66/ 33 IDE
devices. You can attach a maximum of two IDE devices, such as hard disk drive (HDD),
CD-ROM, DVD-ROM, etc. using IDE ribbon cables.
In general, two IDE devices can be attached onto one IDE connector. If you attach two IDE
HDDs, you must configure one drive as the master and the other one as the slave.
SATA II Connectors: SATA1/ SATA2/ SATA3/ SATA4
The four SATA II connectors support 3 Gbps transmission speeds and RAID 0/1/ 0+1/ JBOD
mode. One SATA connector only can attach one SATA HDD of each time using SATA cables.
Pin
Assignment
Pin
Assignment
1 Ground
2 TX+
3 TX-
4 Ground
5 RX-
6 RX+
SATA1~4
7 Ground
This mainboard supports RAID 0/ 1/ 0+1/ JBOD mode; refer
Appendix II
for more information.
Attention
The IDE cable is designed and should be attached with a specific
direction. One edge of the cable will usually in color such as red, to
indicate that should line up with the header pin-1.