Albalá Ingenieros | Manual
IPA3000C01
The following functions of the IPA3000C01 can be performed remotely:
- Configuration of the operating mode.
- Selection of the inputs and priorities for the output.
- Configuration of the IP transmission and reception parameters.
- Supervision of the status of the inputs and outputs.
4.7.1. Details of the IPA3000C01 registers
The IPA3000C01 module provides control and status registers that can be read and
written by means of specific commands described in the communication control
module user manuals.
The parameter information grouped in the CONTROL or RAM sections is stored in
volatile memory. Any modifications to the parameters will be lost when the module
power supply is disconnected unless the "EEPROM Save" button within the software
has been pressed.
The STATUS section parameters are read-only and cannot be modified.
The EEPROM section parameters are rarely used and are stored directly in non-volatile
memory.
The parameters that can be controlled and supervised remotely for each version of
the firmware are listed below:
VERSION 1.X
CONTROL
Name
add
ext
msk
snmp trap
Description
MODE
0x00
0x03
Y
Y
Allows selecting the switching mode
0=Full auto, 1=Half auto, 2=Manual
DVB_T_MODE
0x00
0x04
Y
Y
Selects DVB-T mode.
0=No, 1=Yes
NULL_PCK_RTP
0x00
0x08
Y
N
Selects if NULL packets are inserted if there are unrecovered packets when
using RTP protocol
0=No, 1=Yes
NARROW_PLL_BW
0x00
0x10
Y
N
Allows selecting a narrow PLL bandwidth in the clock packet PLL in non DVB-T
mode to achieve a very stable bitrate
0=No, 1=Yes
BUZZER
0x00
0x20
Y
N
Allows buzzer operation
0=Disabled, 1=Enabled
SEAMLESS_PRIOR
0x00
0x40
Y
N
Selects if seamless status has priority over input priority in hafl-auto mode
0=No, 1=Yes
EN_SEAM_NONDVBT
0x00
0x80
Y
N
Allows enabling seamless mode with non DVB-T signals
0=No, 1=Yes
INPUT
0x01
0x03
Y
Y
Selected input
0=ASI Main, 1= ASI Reserve, 2=IP Main, 3= IP Reserve
1PPS_FAIL_MASK
0x02
0x01
N
N
Allows masking fail in 1PPS input
0=Disabled, 1=Enabled
10MHZ_FAIL_MASK
0x02
0x02
N
N
Allows masking fail in 10MHz input
0=Disabled, 1=Enabled
INPUT_ST_CHANGE
0x02
0x04
Y
N
Signals a change in fail status
0=No, 1=Yes
29
