securityProbe 5ESV Manual
Updated until firmware 404m
- 40 -
Continuous Time Settings Tab
The following advanced functions are for setting the time frame in which the system
should delay a notification being triggered when a sensor gives a reading that exceeds
the thresholds (high warning, normal, etc).
Continuous Time to Report High Critical:
This helps to eliminate unnecessary
messages during minor fluctuations. You can set the amount of time to delay a
notification of a status change from high warning to high critical. Enter the time in
seconds and press the
“Save” button. The amount of time that can be entered is between
0 and 65535 seconds which equals approximately 18 hours
Continuous Time to Report High Warning:
As above but delays notification for “High
Warning”
Continuous Time to Report for Normal:
As above but delays notification for return to
“Normal” state
Continuous Time to Report for Low Warning:
As above, but delays notification for
“Low Warning” state.
Continuous Time to Report for Low Critical:
As above but delays notification for “Low
Critical” state.
Continuous Time to Report for Sensor Error:
As above, but delays notification being
sent for sensor going into an error state.
Example
: An airflow sensor or humidity sensor may have temporary drops in readings
which are normal operating characteristics; a logical time limit is set to show abnormal
conditions.
