3516526A02 Ed. 01
13
Step 11:
Select the superheating set point (See page 18)
Step 12:
Set all other parameters to default?
dFP=0
No, the other parameters do not need to be changed.
dFP=1
Yes, set all other parameters to their default values.
This option only appears if this is not the first time the set-up wizard has been run.
The initial configuration is now complete, and the device will start to regulate the temperature.
The configuration wizard will not reactivate. To reactivate it, activate the stand-by mode (by pressing the
m key for 3 seconds) and wait until the unit completely halts regulation (the m indicator will light up
permanently) and press the
,
,
SET
buttons in this order in sequence, not at the same time.
If the Pump Down function is active, there may be a delay between the initiation of the Stand-by function
and the moment the controller stops (See page 19).
Operation
Messages
Pump down malfunction error (Stop). The time configured in parameter C20 has been
exceeded (See page 19). Only displayed on screen.
Pump down malfunction error (Start). The time configured in parameter C19 has been
exceeded (See page 19). Only displayed on screen.
Sensor 1, 2, 3, 4, 5 or 6 is faulty (open circuit, crossed circuit, or value outside
sensor limits).
Activates the alarm relay and the audible alarm.
Open door alarm. Only if the door stays open for a longer time than defined in parameter
A12 (See page 29). Activates the alarm relay and the audible alarm.
Maximum temperature in control sensor alarm. The temperature value programmed in A1
has been reached (See page 28). Activates the alarm relay and the audible alarm.
Minimum temperature in control sensor alarm. The temperature value programmed in A2
has been reached (See page 28). Activates the alarm relay and the audible alarm.
External alarm activated (by digital input) (See page 28). Activates the alarm relay and
the audible alarm.
10
/
/ SET
Summary of Contents for 16526A
Page 43: ...3516526A02 Ed 01 43...