Replacing Batteries in the Transmitter
25 (28)
Sesam 800 L99 RX/RXD/RX DIN (original instructions)
Document-ID: 942858-000 EN
Version: C1
Author: SH
15
Replacing Batteries in the Transmitter
If the display on the transmitter indicates
“
L O b A T
”, replace the batteries promptly. Note that changing of batteries
must take place in a clean environment free from static electricity.
The batteries are changed as follows:
1. Open the battery cover by unscrewing the 6 screws on the backside of the
transmitter housing (see fig. 15).
2. Carefully remove the cover by lifting up the front end of the cover
(see fig. 17).
3. Remove the batteries.
4. Insert the new batteries.
5.
Close the cover by first inserting the backside of the cover in the transmit
-
ter, and the pressing the front down (see fig. 17).
6. Tighten the 6 screws with PH2 (torque 1 Nm).
Figure 15.
Battery cover
and the screws
holding the
cover
Figure 16.
Batteries in the
transmitter
Figure 17.
Back side of the cover inserted in its position
