Indicators on the Receivers
11 (28)
Sesam 800 L99 RX/RXD/RX DIN (original instructions)
Document-ID: 942858-000 EN
Version: C1
Author: SH
9
Indicators on the Receivers
9.1 Sesam 800 RX
The Sesam 800 RX model has seven LED indicators that are displaying system
information (see fig. 1 for positions of the LEDs).
The indications on the LEDs are as follows:
LED 1 Relay 1 status: LED ON indicates that the relay is active.
LED 2 Relay 2 status: LED ON indicates that the relay is active.
LED 3 Relay 3 status: LED ON indicates that the relay is active.
LED 4 Power:
Indicates whether the receiver is powered on or
not.
LED 5 Squelch:
Indicates a detected signal on the operating
frequency band.
LED 6 Status:
Indicates that information from a transmitter as-
sociated with the receiver has been received.
LED 7 Learn:
Indicates if the transmitter is in Learn Mode
9.2 Sesam 800 RXD
The Sesam 800 RXD model has an integrated display that shows additional
system relevant information (see fig. 5).
At activation of a certain function, the transmitter memory position will be
shown in the display window.
If a relay is activated, the following will be shown in the display:
•
Left decimal point: Relay 1 activated.
•
Both decimal points: Relay 2 activated.
•
Right decimal point: Relay 3 activated.
•
Number of used memory position.
At start up, the display will show system information in the following order:
•
System version.
•
“
r
” if a memory card is installed.
•
Programmed door number.
