Configuration of the Receiver
14 (28)
Sesam 800 L99 RX/RXD/RX DIN (original instructions)
Document-ID: 942858-000 EN
Version: C1
Author: SH
10.3.2
Advanced Configuration
This configuration allows the user to choose at what memory position a certain
transmitter shall be stored in.
Adding a transmitter in a certain memory position
1. Press the “Learn/Erase” button.
The display window shall show “L r n” followed by the memory posi-
tion that the transmitter will be stored in. The right decimal on the display
flashes as long as the Learn mode is active (10 seconds).
2. To select what memory position to use (memory positions can be 1-500)
press the Memory Position UP or Memory Position DOWN buttons
(see fig. 5). The left decimal on the display indicates whether the chosen
memory position is already used.
3. Press ARROW UP on the transmitter.
The display will show “
A
” and will return to normal operating mode.
10.3.3
Erasing Transmitters in the Receiver SESAM 800 RXD
Erasing individual transmitters
1. Press the “Learn/Erase” button.
The display shows “
L r n
” followed by the memory position that will be
erased. This mode will be active for 10 seconds.
2. Change what memory position to delete (1 to 500) by using “+” and “-” buttons.
The left decimal in the display window indicates whether the memory position
is in use or not (note that two decimals are shown in the display).
3. Press the “Learn/Erase” button to remove the selected memory position.
The display will show “
D E L
” and return to normal operation.
Erasing all transmitters
1. Press the “Learn/Erase” button.
The display shows “
L r n
” followed by the memory position that will be
erased. This mode will be active for 10 seconds.
2. Press the “Learn/Erase” button for 5 seconds to erase all memory positions.
The display will show “
D E L
” “
A L L
” and return to normal operation. All transmit-
ters are now erased from the receiver memory and, if connected, the memory card.
