12
Push the power switch (O: Off, I: On). The power indicator on the front of the panel
should now display red, indicating that the LCD TV is in standby mode.
Use the included power cord and connect to an earthed 100-240V, 50/60Hz AC outlet.
Note: Shut down the power switch, turn on it again after the power indicator is extinguished
entirely.
Signal input and other terminals:
A.
COAXIAL OUT
: This terminal is used as a digital audio output to audio amplifier.
B.
RS-232
: The D-SUB 9 pins terminal is used as a control port for serial communication
between PC and Panel.
C.
D-SUB(VGA) INPUT
: For PC display purpose. Connects to the Mini D-Sub 15 pins
analog output connector of the PC display card.
D-SUB(VGA) AUDIO INPUT
: Connect the audio terminal to the audio output terminal
of the PC.
D.
YPbPr INPUT
: Connect the separate component video cables to the device having
component video outputs (YPbPr) to the
YPbPr
jacks of the TV.
YPbPr AUDIO INPUT
: Connect the audio cable to device’s audio
L
and
R
jacks and
to the
L
and
R
audio jacks of the TV.
E.
VIDEO INPUT
: Connect the component video input terminal to the component output
terminal of the video output device.
F.
S-VIDEO INPUT
: Connects to the S-Video out jack of your VCR or other video
equipment that has S-Video.
G.
AUDIO INPUT
: Connect the audio input terminal to the audio output terminal of
the video output device. With S-VIDEO audio input signals share this terminal.
H.
RF IN
: Connect antenna or cable 75 Ohm coaxial Aerial to receive TV/CABLE signal.
I.
AUDIO OUTPUT
: Connect audio amplifier or other TV set that with audio input.
