AJA Ki PRO ULTRA, Installation & Operation Manual

Page: 49 / 98

Ki Pro Ultra v1.2r1 www.aja.com 49
1.90 SUPER OUT
This parameter provides superimposition of timecode and transport state (Record, Pause,
etc.) onto the SDI or HDMI monitor outputs. Note that Super Out applies only to the 2K/
1080 SDI/HDMI monitor outputs, not the 4x 3G-SDI outputs or 4K/UltraHD HDMI output.
The 4x 3G-SDI outputs are always “clean” outputs. These are the options:
1.93 OVERLAY
This parameter adjusts the opacity of the Display Overlays. These are the options:
• 100%
• 75%
• 50%
• 25%
2.1 VIDEO INPUT
This parameter selects a video input source from the video input connectors that are
available. This selection impacts the type of video that can be recorded and/or passed
through. These are the options:
NOTE: Choosing the correct video input is a key component of successfully using the AJA Ki Pro Ultra.
Be sure to determine the correct signal type being provided by your camera or video source
before configuring the 2.1 Video Input selection; if an incorrect selection is made, unexpected
or undesirable recordings may result. If you are unsure of your signal type, you may use the
built-in confidence monitor and the STATUS menu to help determine the correct selection.
2.15 Image Division
Input
This parameter is used to select between Square Division or Two Sample Interleave input
format (4K and UHD signals only). Ki Pro Ultra can be set to use VPID to determine the
input format. However, external equipment does not always report the correct VPID.
Therefore, it may be necessary to force the input to Square Division or 2SI. Menu options
are:
Off (default)
SDI Monitor
HDMI Monitor
SDI/HDMI Monitor Superimposition is disabled
Superimposition is enabled for the SDI output
Superimposition is enabled for the HDMI output
Superimposition is enabled for the SDI/HDMI outputs
SDI 1 YCbCr
SDI 1 RGB
SDI 1-2 YCbCr
SDI 1-2 RGB
SDI 1-4 YCbCr
SDI 1-4 RGB
Fiber 1 YCbCr
Fiber 1 RGB
Fiber 1-2 YCbCr
Fiber 1-2 RGB
Fiber 1-4 YCbCr
Fiber 1-4 RGB
HDMI Sets SDI 1 to YCbCr input
Sets SDI 1 to RGB input
Sets SDI 1-2 to YCbCr input
Sets SDI 1-2 to RGB input
Sets SDI 1-4 to YCbCr input
Sets SDI 1-4 to RGB input
Sets Fiber 1 to YCbCr input
Sets Fiber 1 to RGB input
Sets Fiber 1-2 to YCbCr input
Sets Fiber 1-2 to RGB input
Sets Fiber 1-4 to YCbCr input
Sets Fiber 1-4 to RGB input
Sets input to HDMI connector
Auto (default)
Square
2SI
Attempts to use VPID to determine the input format. If there is
a signal/format mismatch a warning/alarm is raised.
Forces the input to Square Image Division.
Force the input to 2SI image division.