FS1-X v1.1
www.aja.com
87
30.0 Mix Down
Reset
This parameter resets all of the mix down levels (five or seven input, two output) for the
selected mixer to the factory defaults.
..
34 Embedded Audio
Out
This parameter selects whether or not audio is embedded in the SDI1/SDI2/Fiber1/Fiber2
outputs.This setting affects both Video Processors 1 and 2
AUDIO OUTPUT Menu Group
The Audio Output Menus control the FS1-X’s audio routing. Any audio input can be
routed to any output, including embedded audio. The general routing procedure using
the FS1-X front panel is to select the menu of the audio output with the Select knob, and
then select the input source you wish to route to that output with the Adjust knob.
Channel mapping allows different sources to be routed to different outputs
1.0 SDI1 Audio Out
This parameter selects the Audio Input Sources for the SDI1 audio output channels.
The factory default for each output is the corresponding input: i.e. SDI1 to SDI1, SDI2 to
SDI2, etc.
When set to SDI1, SDI2, Fiber1, Fiber2, MADI BNC, MADI Fiber, HDMI or Analog:
• The selected source channels are routed to the corresponding output channels. For
example, SDI1 input Ch n to SDI1 output Ch n, where n = 1 thru 16.
• If the destination (output) has more channels than the source, then mute (silence) is
routed to the channel outputs beyond the source channel range.
Mix Down 1
Mix Down 2
Resets the Mix Down 1 mixer levels to default settings.
Resets the Mix Down 2 mixer levels to default settings.
On
Mute
Off
The output of the Audio Processor is embedded in the Video
Processor output.
Audio packets are embedded, but they are set for silence.
No embedded audio (HANC) is generated.
SDI1
SDI2
Fiber1
Fiber2
AES/EBU
MADI BNC
MADI Fiber
HDMI
Analog
The selected source channels are routed to the corresponding
output channels. If the output has more channels than the source,
mute (silence) is routed to the higher numbered output channels.
If the output has fewer channels than the source, the sources are
routed to the lower numbered output channels.
Sig Gen 1KHz
Sig Gen 400Hz
Mute
The selected tone or mute is routed to every output channel.
Map
The currently configured mapping is applied to each output
channel. Channel mapping menus for each output become
available.
Mix Down 1 L:R
Mix Down 2 L:R
The stereo output of the Mix Down Module (1 or 2) is routed to the
SDI output.
