34
Firmware Version After 2.3
Important: It’s strongly recommended NOT to use the Panasonic wall controller
and the gateway at the same time. It may damage the indoor PCB in long term
and in extreme weather conditions.
1. Wire AirTouch 2+, gateway and AC indoor as per diagram below and leave
the dipswitches on the gateway at their default position (gateway as Slave).
Make sure all wires are connected properly.
2. Initialise the AC Unit with Panasonic AC Wall Controller connected.
The Panasonic wall controller can be wired to R1 and R2 in parallel with the
gateway
3. Remove the Panasonic wall after commissioning and set the gateway as the
Master by switching position one of S1 to On (1)
4. If AirTouch 2+ sensors are to be used for AC temperature control, go to
AirTouch 2+ AC setting and select proper sensor/combination.
(657213) Commissioning notes
Wiring Diagrams contd.
Summary of Contents for AirTouch 2
Page 1: ...airtouch net au Installer Manual...
Page 4: ...4 Compatible Brands Compatible Brands...
Page 19: ...19 Zone Setting...
Page 67: ...67...
