Airtec Expert CYPRES 2, User Manual

Page: 38 / 74

- CYPRES 2 User’s Guide - page 37
4.7 Changing the filter
Filter removal: Hold the CYPRES 2 filter changer
by the non-slotted end and push it straight (without
tilting) onto the filter up to the stop position.
Tightly grip the filter
changer, twist it off by
turning it counterclock-
wise and remove the fil -
ter. If there is water in
the casing (behind the
filter), dry it with a cloth.
Remove the old filter from the filter changer by
pushing it with your finger or with the eraser end
of a pencil. Discard it.
Filter installation: Place the new filter with the
labeled side facing, and into, the slotted end of
the filter changer up to the stop (flush) position.
Do not tilt.
Hold the filter changer by the non-slotted end and
gently slide the filter fitting into the unit while
holding it straight (without tilting it). Turn the
filter changer clockwise - initially there will be
little resistance. Continue turning the filter changer
until it slips on the filter (the filter stops turning but
the changer continues to turn). Remove the filter
changer from the filter by pulling it straight back.
Do not use other tools!
The unit must be switched off
before changing the filter.