2-17
2.11. DHCP Server
Networking
DHCP Server
DHCP server will automatically start up when the CPE is powered on if “DHCP
server” is enabled. If enabled, this page shows the previous configuration of the
DHCP server as shown in Figure 2-17; otherwise, it shows that the DHCP server is
disabled as shown in Figure 2-18. Note that “Primary DNS” and “Domain Name” are
required for DHCP server settings, and “Max lease time (seconds)” is between 1 and
99999999. Specific IP address can also be assigned to a specific MAC address in
“Permanent Host Configuration” as shown in Figure 2-17. Please note that DHCP
server is only applicable when the CPE is in NAT mode. After setting the
configurations of these fields, press the “Apply” button to write the new
configurations into the CPE and press “Reboot” as shown in Figure 2-34, to reboot
the system in order for the new configurations to take effect.
Figure 2-17 DHCP Server Enabled
Summary of Contents for ASMAX2300
