AirLive SNMP-FSH2602MG User’s Manual
26
MAC Address Age-out Time
Type the number of seconds that an inactive MAC address remains in the switch's
address table. The valid range is 300~765 seconds. Default is 300 seconds.
Max bridge transit delay bound control
Limit the packets queuing time in switch. If enable, the packets queued exceed will be
drop. These valid values are 1sec, 2 sec,4 sec and off. Default is 1 seconds.
NOTE: Make sure of “Max bridge transit delay bound control” is enabled before
enable Delay Bound, because Enable Delay Bound must be work under “Max bridge
transit delay bound control is enabled” situation.
Broadcast Storm Filter
To configure broadcast storm control, enable it and set the upper threshold for
individual ports. The threshold is the percentage of the port's total bandwidth used by
broadcast traffic. When broadcast traffic for a port rises above the threshold you set,
broadcast storm control becomes active. The valid threshold value is 5%, 10%, 15%,
20%, 25% and off.
Priority Queue Service settings
(Administrator Menu -> Switch Settings->Advanced)
“The Priority Queue Service settings” is where you can configure the 802.1p Priority and
QoS settings. This is also the place where users can enable or disable the 802.1x
authentication protocol. You can find this setting in the Administrator->Switch Settings
->Advanced menu.
Figure 4-10 802.1p Priority Settings
