8
DV50 DV80
(Integral CO
2
Sensor)
INTRODUCTION
INTRODUCTION
INTRODUCTION
Ventilation has to be constant for the indoor air to stay healthy for
the dwellers and the structures of the dwelling. Even for longer
holidays, it is not advisable to stop the ventilation, because the
indoor air will become stuffy and, during the heating season, the
indoor air humidity may condense in the ventilation ductwork and
structures, causing moisture damage.
You can control and automate the ventilation unit operation in the
following ways:
•
By using a control panel installed in the building
•
Through the Home local network connection and the Web
interface
•
Through the Adroit Cloud Service and the Web interface
•
Through a remote monitoring service or building automation
by using voltage signals or Modbus messages
The required ventilation may also be adjusted automatically with
the optional carbon dioxide and humidity sensors. In this case,
ventilation remains optimal even if the dwelling is unoccupied.
By using the week clock, you can create just the right ventilation for
your individual lifestyle.
The following settings will be configured during the setup of the
ventilation system:
• user interface language
• time and date
• system administrator password
• parental controls, if turned on
• fan settings
• user profile settings, such as the temperature.
The qualified ventilation installer must complete the fan settings in
accordance with the ventilation plan. Do not change these settings.
STARTING THE UNIT
If you are starting the ventilation unit for the first time or after a
maintenance procedure, first connect it to the mains. During the
start-up, the diagnostics display will appear for a few seconds, after
which the main display of the At home profile opens.
If the ventilation unit was turned off from the control panel (see Turning
the Unit Off), you can start it by pressing any control panel button.
Updating the unit software
Disconnect the ventilation unit from the mains electrical supply.or
turn off the fuse.
Connect the computer to the digital controller of the ventilation unit
using a USB MicroB connector.
Start the ventilation unit. A USB sign will appear on the display of
the control cannot be used when it is connected to the computer.
Transfer the update file you have downloaded onto the ventilation
unit. Copy the update file HSWUPD.
WARNING
The unit is not intended for use by
children under 8 or by persons with
reduced sensory, physical or mental
capabilities, or whose lack of knowledge
and experience do not ensure safe
operation of the unit.
Such persons can use the unit
under supervision, or by following
the instructions of someone who is
responsible for their safety.
SWITCHING THE UNIT OFF
If you want to switch off the ventilation
unit, proceed as follows:
1. Select
Settings
> Turn unit
OFF
.
2. Press the
OK
button.
3. The system asks for confirmation.
4. Press the
OK
button.
5. The ventilation unit is now
switched
OFF
.
TIP
The Adroit Digital Controller
automatically switches to the sleep
mode when the Sleep time set in the
Display settings has elapsed. You can
wake up the control panel by pressing
any control panel button.
NOTE
The first starting of the unit may take a
while, because of the software version
check.
(Please note! Do not alter the file name!) you
have downloaded at the root of the control
panel (the control panel will be displayed
on your computer as a mass memory or a
removable disk drive). When the file has
uploaded onto the control panel, remove the
USB cable. Next, the control panel will take
a while to load the update. The control panel
will now start to load the update file onto the
motherboard. This can take several hours.
The control panel will remain turned on, but
it is recommended that the control panel be
not used during that time. When the update is
ready, the unit will restart automatically.
