506878-01
Page 34 of 62
Issue 1139
CONDENSATE TRAP LOCATIONS
(Unit shown in horizontal right hand discharge position
)
Figure 45
*Piping from furnace must slope down a minimum
of 1/4” per ft. toward trap.
Figure 46
UNIT WITH EVAPORATOR COIL
Condensate line must slope downward away from the trap
to drain. If drain level is above condensate trap, condensate
pump must be used. Condensate drain line should be routed
within the conditioned space to avoid freezing of condensate
and blockage of drain line. If this is not possible, a heat
cable kit may be used on the condensate trap and line.
Heating cable kit is available in various lengths; 6 ft. (1.8 m)
- kit no. 26K68; 24 ft. (7.3 m) - kit no. 26K69; and 50 ft. (15.2
m) - kit no. 26K70.
Figure 44
CONDENSATE TRAP LOCATIONS
(Unit shown in upflow position with remote trap)
*Piping from furnace must slope down a minimum of 1/4”
per ft. toward trap.
Do not use copper tubing or existing copper condensate
lines for drain line.
CAUTION
A separate drain line must be run to the drain from the
condensate trap to ensure proper drainage and pressure
switch operation.
DO NOT
connect the condensate trap
drain into the drain line from the evaporator coil.
CAUTION
Summary of Contents for 95G2UHV
