Issue Date: 29 Jan 2009 Rev 1
Page 11
•
ATTACH REAR TOP WIRE. The rear top wire should now be attached to the rear quick clip
block.
•
INSERT TIP BATTENS AND STRUTS. Remove tip bags. There is a strut each for the left side
and right side. When holding the strut with the clip end
toward you and with the clip hook facing up, the white
clip should be outboard and then rotate toward the
keel to tighten. The left hand side is pictured as a
guide. The struts are floating and do not locate at the
front other than by sliding them into their pockets.
Locate the hook in the sail eyelet by moving the
trailing edge onto the batten hook. Close the clip along
the shaft gently but firmly.
•
INSERT UNDER SURFACE BATTENS. The under surface
battens are inserted and pulled back into the rear of the
batten pocket.
•
ATTACH FRONT FLYING WIRES. The ring on the front
flying wires can now be inserted in to the quick clip block.
Ensure that the catch is positively locked. If the glider has
been assembled flat it should now be lifted on to the control
frame. Take care to avoid the tip battens catching on the
ground as you raise it. Keep a firm grip on the keel when
raising the nose from the flat position in strong winds.
Summary of Contents for Sting 3
