Air-Vac PCBRM100, User Manual

Page: 175 / 209

PCBRM100 User’s Guide Chapter 6: Maintenance
4101.00.902 6-19
Flow Meter: Air Flow Table:
Note:
I
T IS RECOMMENDED THAT YOU USE THE TAB KEY TO ENTER INTO THE ADJUSTMENT BOX TO
CHANGE THE SETTING
.
8. If the flow meter reads too high, decrease make 2 clicks on the left side of the track bar (not on the
sliding bar position) (B).
9. If the flow meter reads too low, increase make 2 clicks on the right side of the track bar (not on the
sliding bar position) (B).
Once the 100% Flow Controller value has been set, check flow controller verifications for 20-90% set-
tings (A). With the nozzle flow system activated for the various settings, check the flow using the me-
ter. Adjust the nozzle flow controller computer value (B) as required until the float corresponds to the
scribed setting.
(A)
(B)