Air-Vac PCBRM100, User Manual

Page: 103 / 209

PCBRM100 User’s Guide Chapter 4: Software Overview
4101.00.902 4-65
•
Motion Options
•
Use Panel Heater Station
•
Up-Preheat Approach Ht (mm): (min 0 / max 50) Top preheater has a motor-
ized z-axis set approach height to create oven-type effect (5mm typical)
•
Low-Preheat Approach Ht (mm): (min 0 / max 50) How close board is to bot-
tom preheat panel (5mm typical)
•
Channel: TC channel controlling board temp measurement in preheater (typically
TC 01)
•
Function (drop down menu):
•
Wait TC: Wait in preheater until selected TC channel reaches target temp
•
Average TC: If you see 2 or more TC channels to measure board temp
•
Temperature (°C): (min 0 / max 300) Target board temp (150˚C typical)
•
Maximum Delay (sec): (min 0 / max 1000) Maximum time in preheater before
timeout message and auto board exit (typical time plus 2 minutes)
Board Heating – Maintain
•
Channel: (drop down menu – TC1-TC8) Control TC (typically TC 01 taped on board)
•
SolderPot HotGas (°C): (min 0 / max 600) Temp of left and right bottom blades
•
Channel Temperature (°C): (min 0 / max 650) Target temperature of board (ie. 150˚C)
Start/Stop Function: (drop down menu)
•
On: Bottom heating blades will automatically turn on/off to maintain board temp after pre-
heat
•
Off: Board heating maintain function off (end of program)