Air Live SI-101, User Manual

Page: 16 / 19

1. Overview
AirLive SI-101 User Manual
11
0
Bit1 : 1 means test mode,
0 means normal mode.
Notice:
This bit only effect by the DIP Switch setting to
“customer mode”, otherwise it decides by DIP
Switch setting to Test or Normal Mode.
0
Bit2 : Disable the door/window function.
(1:Disable, 0:Enable)
0
Bit3 : Setting the temperature scale. 0:
Fahrenheit, 1:Celsius
0
Bit4 : Disable the illumination report after
event triggered. (1:Disable, 0:Enable)
0
Bit5 : Disable the temperature report after
event triggered. (1:Disable, 0:Enable)
0
Bit7: Disable the back key release into test
mode. (1:Disable, 0:Enable)
6(*) Multi- Sensor
Function
Switch 4 All
Multisensor function switch. Using bit to control
0
Bit0 : Disable magnetic integrate illumination
to turn ON the lighting nodes in the
association group 2. (1:Disable, 0:Enable)
0
Bit4 : Disable delay 5 seconds to turn off the
light, when door/window closed.
0
Bit5 : Disable auto turn off the light, after
door/window opened to turn on the light.
(1:Disable, 0:Enable)
Notice: If bit2 is zero, this setting is useless.
Notice: If the configuration No.9 is zero, this
setting is useless.
7(*) Customer
Function 4 All Customer function switch, using bit control.
0
Bit3 : Disable send out BASIC OFF after
door closed. (1:Disable, 0:Enable)
0
Bit4 : Notification Type,
0: Using Notification Report. 1: Using
Sensor Binary Report.
0
Bit5 : Disable Multi CC in auto report.
(1:Disable, 0:Enable)
0
Bit6 : Disable to report battery state when the
device triggered. (1:Disable, 0:Enable)
9 Turn Off Light
Time 4 0 ~
8 seconds per tick, default tick is 4 (32