Air Live SI-101, User Manual

Page: 10 / 19

1. Overview
AirLive SI-101 User Manual
5
1.3.5. Timing Report
Beside the event triggered could report message, the device also support the timing
unsolicited report of the status.

Battery level report: Every 6 hours report once in default. It could be changed by
setting the configuration NO. 10.

Low battery report: When the battery level is too low, every 30 minutes will report once.

Door/window state report: Every 6 hours report once in default. It could be changed by
setting the configuration NO. 11.

Illumination level report: Every 6 hours report once in default. It could be changed by
setting the configuration NO. 12.

Temperature report: Every 6 hours report once in default. It could be changed by
setting the configuration NO. 13.
Notice: The configuration NO. 10, 11, 12 and 13 could be setting to zero to disable the auto report.
And the configuration NO. 20 could change the tick interval, the default value is 30, if setting to 1,
that means the minimum auto report interval will be one minute. And please notice if setting this
value to zero, that means disable all of the timing report except the low battery detection.
1.4 Power Up Procedure
1.4.1. Battery Power Check
When the device power up, the device will detect the power level of the battery immediately.
If the power level is too low, the LED will continue flash about 5 seconds. Please change
another new battery.
1.4.2. NWI
When the device power on, the device will check is it already adding to the network? If
doesn't, it will auto start the NWI mode. The LED will flash in every second and continue 30
seconds. Until timeout or the device successful to inclusion by controller. The use can press
the tamper key 3 times to abort the NWI mode.
1.4.3. Wake
When the device power on, the device will wake about 20 seconds. In this duration, the
controller can communicate with the device. Normally the device is always sleeping to save
the battery energy.