Air innovations 99H0360-10, Installation, Operation And Maintenance Manual, Page: 59 / 85

59
4. Drill two one-eighth inch holes and insert anchors
within the mounting surface. Anchors may not be
required if securing to a wall stud or racking
system. Insert the screws into the holes and test fit
the backing plate for mounting to ensure it mounts
easily onto the two screws and slides down onto the
slotted openings freely. (Fig. 3)
5.
Plug in the communication cable to the remote
sensor and mount the Remote Sensor to the wall.
(Fig. 3)
6.
Reattach the sensor’s faceplate (Fig. 4)
7.
If multiple sensors are being used either connect
each Sensor to each other in series using RJ-9 cable
or purchase a RJ-9 Splitter
(Fig. 5) to be connected to the unit.
NOTE:
Remote Sensor’s will always be treated as
“enabled” when hardwired. Their temperature and
humidity readings will always be calculated
towards the average by the system.
Fig. 3
Fig. 4
Fig. 5