Air innovations 99H0360-10, Installation, Operation And Maintenance Manual, Page: 57 / 85

57
Mounting the Remote Interface Controller (Wireless)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
1. Disconnect the controller wire from the side of the Wine
Guardian unit and save for future use.
2. Plan on mounting the remote interface controller on a
solid surface away from doors, corners, air outlets, drafts
or heat generating equipment. Do not mount the remote
interface controller directly on an outside wall, a wall
adjacent to a boiler room, or other hot area. Use a piece
of foam insulation behind the sensor to insulate it from a
hot or cold surface. The recommended height is four to
five feet above the finished floor.
3. Unscrew and remove the back plate from the Remote
Interface Controller (Fig. 1)
4. Place the back plate against the wall and mark the
mounting points at the desired location. (Fig. 2)
5. Drill two one-eighth inch holes and insert anchors within
the mounting surface. Anchors may not be required if
securing to a wall stud or racking system. Insert the
screws into the holes and test fit the backing plate for
mounting to ensure it mounts easily onto the two screws
and slides down onto the slotted openings freely (Fig. 3)
6. Reattached the back plate to the Remote Interface
Controller. (Fig. 4)
7. Insert the three AA batteries.
(only applicable with wireless installations)
8. The system will automatically acknowledge a wireless
device (Remote Interface or Remote Sensor). Go to
Setting “30” to define the Remote User Interface use.
9. Attach controller to the wall.