AIC SB401-VG, User Manual, Page: 66 / 91

57
Chapter 4. BIOS Configuration Settings
4.4.7 PCH Configuration
PCH Configuration
PCH Devices PCH state after G3 S0 S5 Last State
PCH SATA
Configuration
SATA Controller Enable Disable
Configure SATA as AHCI RAID
Support Aggressive
Link Power
Management
Enable Disable
Port 0~7 Enable Disable
SATA Port 0 DevSlp Enable Disable
Hot Plug Enable Disable
Configure as eSATA Enable Disable
Mechanical Presence
Switch
Enable Disable
Spin Up Device Enable Disable
SATA Device Type Hard Disk Drive Sata State Drive
SATA Topology Unknown ISATA
Direct
Connect
Flex M2
PCH sSATA
Configuration
sSATA Controller Enable Disable
Configure sSATA as AHCI RAID
Support Aggressive
Link Power
Management
Enable Disable
Port 0~5 Enable Disable
sSATA Port 0~5
DevSlp
Enable Disable
Hot Plug Enable Disable
Configure as eSATA Enable Disable
Spin Up Device Enable Disable
sSATA Device Type Hard Disk Drive Sata State Drive
SATA Topology Unknown ISATA
Direct
Connect
Flex M2
USB Configuration
USB Precondition Enable Disable
USB Per-Connector
Disable
Enable Disable
USB XHCI MSI
Disable WA
Enable Disable
XHCI Over Current
Pins
Enable Disable
XHCI Wake On Usb
Enable
Enable Disable
Place XHCI BAR
below 4GB
Enable Disable
ADR Configuration
Enable/Disable ADR Platform-POR Enable Disable
ADR GPIO GPIO B GPIO C
Host Partition Reset
ADR Enable
Platform-POR Enable Disable
Enable/Disable ADR
Timer
Platform-POR Enable Held-off
ADR timer expire
time
Platform-
POR
0 uS 25 uS 50 uS 100 uS
ADR timer multiplier Platform-POR
x1, x8, x24, x40, x56, x64, x72, x80,
x88, x96