agromaster F 1000, Operator'S Manual And Spare Parts

Page: 24 / 105

1. S if the shaft length is longer.
Don't exceed the PTO shaft speed of 540 rpm. Angle of shaft must be
max 20° (Fig. 8).
2. Use the regulator while running and stopping the pump.
3. Don't run the machine on excessive
vertical and inclined fields.
4. Don't run the machine when the tank
is empty.
5. Don't exceed the maximum pressure
of the pump.
6. Don't run the pump without grease.
7. Don't run the pump without antifreeze.
8. Disengage the regulator latch while running and stopping the machine
9. Don't detach the safety valve on the pump pressure mechanism. Don't
break down the adjustments. If the pressure of pump is more than 20%
then this valve opens and begins to evacuate the liquid into tank.
haft can be cut to required lenght,
7. USAGE OF THE MACHINE
7.1. PUMP OIL LEVEL AND ANTIFREEZE
7.2. SUCTION HOSE
The level should be between two marks on the oil bottle. Add the 20 W-30
engine oil, if the level falls below the lower mark (Fig. 9). In oil bottle, oil level
must be between two indicators. If oil level is less than bottom indicator, then
fill the 20W-30 engine oil. Use the antifreeze for pump to prevent freezing in
cold weathers. Before or after operating of machine, check the antifreeze level.
The amount of antifreeze differs between 1-2L depending on bottle size (Fig. 10).
There shouldn’t be air leak in the suction mechanism. Check the elbow nut
(Fig. 11), hose clamps (Fig. 12), gasket and o-rings and tighten them if necessary.
Otherwise the pump efficiency is decreased due to the air leakage.
Fig. 9
Fig. 11 Fig. 12
Max. 20°
Fig. 10
Fig. 8
23