AGRI TRONIX Brecknell SBI-521 Series, Service Manual

Page: 73 / 82

SBI521 Service Manual 71
8.2 Display Symbols
Symbol Description
0------ Zero is over the setting range
0_______ Zero point is below the setting range
Ad------ Signal to ADC is over maximum range
Ad______ Signal to ADC is below minimum range
-------- Weight is over upper limitation or display data is over limitation
________ Weight is below lower limitation
EEP.E1 CONFIG or CAL parameters are not correctly set
EEP.E2 USER parameter is not correctly set
Lo.bAt Battery voltage is lower than setting
CAP.- - - Next displaying content is capacity
CAP.ER Parameters about Capacity is not correct
CAL.Px Calibration on point (x)
CAL.OFF Calibration seal switch is on OFF position
CAL.ON Calibration seal switch is on ON position
CAL.Er Calibration error, maybe input data or loaded weight is incorrect, unstable, non-linear
CAL.End End calibration
OFF Power OFF the indicator
STB.ER Unstable time is larger than setting of USER-OTHER-NLD.RNG
AC.xxxx Accumulation times is xxxx
PR.TARE Preset TARE weight
COMP Input COMPARE data mode
HIGH Input HIGH limitation data of Comparison
LOW Input LOW limitation data of Comparison
SPL.Lo Sample load weight of low point.
SPL.HI Sample load weight of high point.
SPL.PWT Sample goods weight to calculate piece weight
INP.PCS Input number of pieces being counted
UNIT.KG Unit kg is selected
UNIT.LB Unit lb is selected
PWT.ER Piece weight error, sample too small (<0.5d)
SPL.PCT Sample goods weight to calculate
INP.PCT Input percentage of weighted goods
PCT.ER Unit percentage weight is too small (<0.5d)