BE-BX42S / BE-WC62G USER MANUAL
21
PRE-OPERATION CHECK LIST
Although there are no operational restrictions on the Wood Chipper when used for the first time,
it is recommended that the following mechanical items be checked:
After 1 Hour of Operation:
• Torque all fasteners and hardware.
• Check condition of rotor bearings.
• Check the condition and clearance of the twig breaker, rotor and stationary blades.
Adjust or replace as required.
• Check for entangled material before resuming work.
• Lubricate all grease fittings.
After 10 Hours of Operation:
• Repeat steps listed above (After 1 Hour of Operation)
• Go to normal servicing and maintenance schedule as defined in the Maintenance section.
Efficient and safe operation of the 3-Point Hitch Wood Chipper requires that each operator reads and
understands the using procedures and all related safety precautions outlined in this section.
A pre-operation checklist is provided for the operator. It is important for both the personal safety and
maintaining good mechanical condition that this checklist is followed.
Before operating the Wood Chipper and each time thereafter, the following areas should be checked off:
• Lubricate the machine per the schedule outline in the Maintenance section.
• Check the rotor, blades and twig breaker.
• Remove any twine, wire or other material that has become entangled.
• Check the condition and clearance of the twig breaker, rotor and stationary blades.
Adjust or replace as required.
• Check that all bearings turn freely. Replace any that are rough or seized.
• Make sure that all guards and shields are in place, secured and functioning as designed.
• Check the condition of the curtain in the feed hopper.
It must be in good condition to prevent chips from flying out.
