3.3.
Match the Remote Controller
Remote control linking
（
the aircraft and the remote controller have been linked before shipment
so it can be used after powering on
）
Instructions: When the remote controller and the aircraft are disconnected from the signal; when
the remote controller and the digital link are replaced; when the remote controller does not
respond to the aircraft operation; when the flight controller is upgraded with the upgrade cable;
the remote controller is required to perform the frequency operation to control the aircraft.
The linking process diagram is as follows:
A.
Pull out the water tank, remove screws 1-5, and remove the cover. As shown below.
B.
Power on the aircraft and press and hold the "PAIR" button of the flight control, the indicator
light flashes green quickly, and the switch position is as shown in the figure below.
C.
Open the remote control H12 assistant, as shown below.