AGORA
MODELS
15
9
11
10
Slide the floor until the two screw holes (arrows) at the front of the car
are aligned with the mounting plates below them.
Holding the floor assembly as shown, apply some pressure with your thumb (circled, red) while supporting
the floor with your finger (circled, blue). The screw hole indicated with the blue arrow fits into the recess of
the body work (see photo 12).
Note the four indicated areas at the rear of the car in the pictures
above (circled) located around the boot. You’ll need to bend the floor
assembly slightly to fit these in place.
Stage 93: Fitting the Floor with the Electrical
Circuit Board
