L4411A Getting Started Guide
75
Rack Mounting
4
1. Extend the shelf from the rack such that approximately 50% - 75% of the
shelf surface is outside of the rack. (The tabs on the back of the shelf that run
underneath the rail channel prevent the shelf from tipping.)
2. Determine the position of the instruments (flush, recessed, reversed).
3. Note the location of the four mounting holes on the bottom of the
instrument (Figure 4-1). Set the instrument on the shelf, and align the
mounting holes with the holes on the shelf. Insert four M4x8 flat head screws
(item 1) upward through the bottom of the shelf and into the instrument
mounting holes.
4. Install the second L4411A (if present) in the shelf area adjacent to the first
instrument. If only one instrument is installed, install a filler panel on the
front edge of the unused area. Insert two M4x8 flat head screws (item 1)
upward through the bottom of the shelf and into the panel.
5. Connect the instrument power cord and interface cable(s) (LAN, GPIB,
USB).
Connect the Shelf to the Rack Frame
Once the L4411A is installed and all power cords and cables are routed as
intended, slide the shelf into the cabinet until the shelf handles meet the
front-facing columns of the rack frame. Using two10-32 pan head dress screws
(item 2) per column, secure the shelf to the frame.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
