Agilent Technologies E6630A, Getting Started Manual

Page: 18 / 108

18 Getting Started Guide
1
Quick-Start
8 Verify the installation a From the mouse right-click
menu, select
Utility , Virtual
Front Panel . (All
key-presses that follow
refer to the keys shown on
the Virtual Front Panel.)
b Press System , Show ,
System .
c Verify that the purchased
application(s) appear in the
list.
•
If you require further assistance, contact the Agilent
support team.
Online assistance: http://www.agilent.com/find/assist
9 Attach a loopback cable a Use an RF cable to connect
the front panel RF In and
RF Out ports for this
sub-instrument.
•
The purpose is to use a loopback cable to verify that
the test set’s source can generate a signal and the test
set’s analyzer can measure it.
10 Generate and view a
signal a Press
Input/Output
,
More
,
RF Output & Test Set
Config
,
RF Output,
RF Output
.
b Press AMPTD Y Scale , Ref
Value , 10 , dBm .
c Press FREQ , Center Freq ,
2.4 , GHz .
d Press SPAN X Scale ,
Span , 8 , MHz .
e Press
Source, Frequency,
2.4
,
GHz
.
f Press
Source
,
RF Output
,
On
.
g Press Source , Amplitude ,
RF Power , 0 , dBm .
•
Select RF Output rather than GPS Output.
•
Set the amplitude reference to 10 dBm
•
Set the analyzer center frequency to 2.4 GHz.
•
Set the analyzer span to 8 MHz.
•
Set the source frequency to 2.4 GHz.
•
Set the source RF output to On.
•
Set the source amplitude to 0 dBm.
•
To ensure accurate power levels from the source, see
“Source Level Accuracy" on page 20.
Steps Actions Notes