Agilent Technologies 4263B, Operation Manual

Page: 160 / 325

4263B
:CALCulate1:FORMat f REAL j MLINear j CP j CS j LP j LS g
:CALCulate2:FORMat f IMA Ginary j PHASe j D j Q j REAL j LP j RP j INV g
Sets or queries the measurement parameter .
This command works with the [:SENSe]:FUNCtion[:ON] subsystem. The 4263B makes a
vector measurement of the DUT , using the method specied by the SENSe subsystem. After
the measurement, the scalar measurement parameter specied by :CALCulate{1|2}:FORMat
command is calculated from the measured vector value .
REAL Real part of the vector
IMAGinary Imaginary part of the vector
MLINear Absolute value of the vector
PHASe Phase of impedance
CP Equivalent parallel capacitance
CS Equivalent series capacitance
LP Equivalent parallel inductance
LS Equivalent series inductance
D Dissipation factor
Q Quality factor
RP Equivalent parallel resistance
INV 1/N (Reciprocal of turns ratio N)
F or information on the selection of measurement parameters , refer to \T o Select the
Measurement P arameter" in Chapter 4.
Note
The SENSe:FUNCtion subsystem has priority over the CALCulate{l|2}:FORMat
command. That is ,
When setting the SENS:FUNC:ON command, the setting of the CALC
{1|2}:FORM command is restricted. When the settings of these two
commands do not match any measurement parameter shown in T able 5-2,
the setting of CALC{l|2}:FORM is automatically changed to a measurement
parameter which matches SENS:FUNC:ON .
When setting the CALC{l|2}:FORM command, if the current setting of the
SENS:FUNC:ON command does not match any measurement parameter shown
in T able 5-2, the CALC{l|2}:FORM command is rejected, and an error occurs .
Therefore , before setting the CALC {1|2}:FORM command, the
[SENSe]:FUNCtion:ON command must be set correctly .
GPIB Reference 5-11
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com