Agilent Technologies 2000 X, Service Manual

Page: 10 / 162

10 2000/3000 X-Series Oscilloscopes Service Guide
Figures
Figure 24. Removing the power supply shield screw 107
Figure 25. Unclipping the power supply shield right side 108
Figure 26. Removing the power supply shield - lift and pull
out 109
Figure 27. Removing the BNC nuts and washers 110
Figure 28. Removing the top rear deck screws 111
Figure 29. Removing the bottom right rear deck screw 111
Figure 30. Removing the bottom left rear deck screw 112
Figure 31. Removing the bottom rear deck screws 112
Figure 32. Removing the option module guide to acquisition board
screw 113
Figure 33. Disconnecting the interboard supply cable from the
acquisition board 114
Figure 34. Lifting front bezel latch 115
Figure 35. Separating the rear and front decks 116
Figure 36. Rear and front decks separated 116
Figure 37. Removing the T6 screws (4 channel version) 117
Figure 38. Disconnecting keyboard and display cables from
acquisition board 118
Figure 39. Disconnecting display backlight power cable from
acquisition board 119
Figure 40. Acquisition board mounting screw locations 120
Figure 41. Acquisition board removed from front deck 121
Figure 42. Release the bezel clips from the front deck 122
Figure 43. All bezel clips released 123
Figure 44. HINT: When reinstalling bezel, align ground terminal
first 123
Figure 45. Gently lift front deck from bezel 124
Figure 46. Disconnect the keyboard cable 125
Figure 47. Disconnect the softkey board cable 126
Figure 48. Unclip the softkey board from the bezel 127
Figure 49. Remove the softkey keypad from the bezel 127
Figure 50. Unclip the keyboard board from the bezel 128
Figure 51. Remove the keyboard keypad from the bezel 128