AGILE ALLY PLUS 6287, User Manual

Page: 137 / 186

Page 11-11 6287 ULTRA COMPATIBILITY
52 — SCS EM Always Generates CR/LF
This option is equivalent to ALLY PLUS Option #16. A value of “Y” is
executed as though it were an ALLY PLUS value of 01, and a value of “N”
is executed as an ALLY PLUS value of 00. The General Configuration
Report will display “yes” or “no.”
53 — Ignore IBM 35 Hex Transparency
This option is equivalent to ALLY PLUS Option #60. A value of “Y” is
executed as though it were an ALLY PLUS value of 00, and a value of “N”
is executed as an ALLY PLUS value of 01. The General Configuration
Report will display “yes” or “no.”
Note: This option is different in the ALLY PLUS than it is in the ULTRA, in
that the ULTRA asks “Ignore?” while the ALLY PLUS asks “Allow?” As
such, an ULTRA “Yes” becomes a “No” in the ALLY PLUS.
54 — Power On Reset (POR) After 60 Seconds
This option has no functional equivalent in the ALLY PLUS, because the
user cannot change the POR delay.
55 — MD-Laser Support
This option is equivalent to ALLY PLUS Option #71. A value of “Y” is
executed as though it were an ALLY PLUS value of 01, and a value of “N”
is executed as an ALLY PLUS value of 00. The General Configuration
Report will display “yes” or “no.”
56 — Reserved
This option is reserved in the current ULTRA firmware, and it has no
equivalent in the ALLY PLUS.
57 — DSC NL at EM Even If in Column 1
This option is equivalent to ALLY PLUS Option #27. A value of “Y” is
executed as though it were an ALLY PLUS value of 01, and a value of “N”
is executed as an ALLY PLUS value of 00. The General Configuration
Report will display “yes” or “no.”