Primary Code: 86
Primary Code: 91
Primary Code: 92
Problem: Illegal SCSI Address
Solution: Reset the DIP Switches so that the SCSI address switches
do not specify "7". Refer to page 32.
Secondary Code: 00
Reason for error: The SCSI address switches inside the Display
Panel are set for address " 7". Address "7" is reserved for the
initiator or host. The SlideWriter's Device Address may be set
from "0" to "6" only.
Problem: Memory Fault.
Solution: Turn off the SlideWriter and wait 30 seconds. Turn the
SlideWriter back on and retry the image. If the error persists, there
is a RAM failure.
Secondary Code: 00, 01
Reason for Error: Prior to imaging, the SlideWriter verifies the
checksums of various RAM data areas such as the color look-up
tables (LUTs). This code indicates corruption of one of these RAM
data areas.
Secondary Code: 02 to 07
Reason for Error: On a power-up or reset sequence, the SlideWriter
has detected a memory failure during its memory diagnostics tests.
Code "02" indicates an EPROM check sum failure; the remaining
codes indicate RAM failures. Errors of this nature should be brought
to the attention of a qualified service technician.
Problem: SCSI Interface Fault
Secondary Code: 00
Reason for Error: The SlideWriter has detected a parity error during
data transfer from the host.
Secondary Code: 01
Reason for Error: SCSI Controller fault.
37
