OPERATOR INSTRUCTIONS
Power-Up Sequence
Figure 3-1. POWER Switch Location
• Locate the POWER Switch on the rear panel.
• Turn on the SlideWriter by pressing the right half of the
POWER Switch
The Display Panel is located on top of the SlideWriter. The Display
Panel consists of eight indicator lights, three switches, and a
two-digit LED display. After turning on the POWER Switch the
SlideWriter will begin a warm-up process during which the Display
Panel lights will flash rapidly in various combinations for about two
minutes. During this time the SlideWriter performs internal tests and
calibrates the brightness of the CRT to ensure consistent color
balance. When the self-test and calibration are complete, the
SlideWriter will beep, then run a calibration routine again.
The RED, GREEN, and BLUE Lights will flash.
NOTE The SlideWriter will periodically perform a calibration routine. This is a
normal operation which ensures the proper functioning of the
SlideWriter. It will not interfere with the imaging process.
13
