9
Manual
3 - Way Ball
Valve
To Pool
Must be installed at the
highest point of the
solar collector
BACKWASH
FILTER
(Optional)
Non-return Vavle
Filtration
Winter
Drainage Plug
(Threaded C3)
Close this port to
direct water to solar
matting.
Vacuum Breaker
(air release valve)
Optional - Automatic control
valve available. Please see
page 11 for details
STEP 11
(T) Insert the correct plumbing adaptors to each corner
C6-C8-C9-C13 (See page 8).
Glue imperial
reducing adaptors (C12) onto plumbing adaptor (C6 & C13) and cut to desired diameter. For all threaded fittings,
apply PTFE. tape.
Lubricant
ABS/PVC Glue
STEP 12
Connect ABS/PVC 1.5” plumbing to Poolsolar as per diagram below. You will need to install a 3-way
valve, this will enable you to direct the water flow to the heater and back to the pool. A vacuum breaker will also be
required on solar heating that is 4m or higher above ground level. Vacuum breakers are not required for low level
installations. Once all of the plumbing connections have been made, proceed to step 13.
For other installation methods using an additional booster pump please go to page 13
T
Insert
1.5” Pipe
C6 or C13
50mm - 1.5”
Adaptor
C6 or C13
50mm - 1.5”
Adaptor
Connect
1.25 or 1.5”
Flexible Hose
C12
C12
Summary of Contents for Poolsolar
Page 1: ...Poolsolar Installation Guide...
Page 18: ......
