16
Step 4
Stretch the rubber tube with the inserted
repair nozzle and force it into the pre-drilled
hole (step 2). Use pliers and lubricant to do
this.
The objective is to force the plastic repair
tube down the rubber tubing and create a
seal against the sides of the pre-drilled
hole!
15mm of plastic repair tube should be
inserted into the header.
The repair is now complete.
Force plastic repair tube
into header.
Plastic repair tube
pinches the rubber
tubing against the
header creating a seal.
REPAIRING POOLSOLAR MATTING.
You will need - Scissors, Pliers, Plastic Repair Tube(s) (30mm x 6mm - provided), Lubricant (provided). Tie- Wraps
(provided).
In the event a tube is punctured, carry out the following repair procedure. Do not attempt to glue the tubing back
together. The tubing is made from EPDM and cannot be glued.
Step 1
The rubber that joins the tubes together to
form the solar matting needs to be cut away
either side of the tubing (approximately 2cm)
using a pair of scissors. Be careful not to cut
the tubing!
Step 2
Insert a plastic repair tube (30mm x 6mm -
provided) using lubricant into rubber tubing.
Apply Tie- wrap to either sided of the plastic
repair tube.
The repair is now complete.
Tie-Wrap x 2
30mm Plastic
insert
Summary of Contents for Poolsolar
Page 1: ...Poolsolar Installation Guide...
Page 18: ......
