EN
4
© Copyright LOTRONIC 2022
RIGGING
The LED moving head provides a unique
mounting bracket assembly that inte
-
grates the bottom of the base, the includ
-
ed ‘omega bracket’ and the safety cable
rigging point in one unit (see illustration).
When mounting this fixture on a truss,
be sure to use an appropriate clamp with
the included omega bracket using a M10
screw fitted through the center hole of
the ‘omega bracket’. As an added safety
measure, be sure to attach at least one
properly rated safety cable to the fix
-
ture using one of the safety cable rigging
points integrated in the base assembly.
FUSE REPLACEMENT
Disconnect the power cord before replac
-
ing a fuse and always replace with the
same type fuse.
With a screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact cus
-
tomer support for further instructions. Continuing to use the unit may cause serious damage.
FIXTURE LINKING
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller
or to run synchronized shows on two or more fixtures set to a master/slave operating mode. The
combined number of channels required by all fixtures on a serial data link determines the number
of fixtures that the data link can support.
Important
: Fixtures on a serial/data link must be daisy chained in one single line. Maximum rec
-
ommended serial data link distance: 100 meters.
DATA CABLING
To link fixtures together you must use data cables. If you choose to create your own cable, please
use data-grade cables that can carry a high quality signal and are less prone to electromagnetic
interference.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX CONNECTOR CONFIGURATION
Termination reduces signal errors. To avoid signal transmission problems and interference, it is
always advisable to connect a DMX signal terminator.
POWER LINK
You can power up to 5 units via the POWER IN/POWER OUT connectors from one single mains out
-
let. Connect an IEC cable from the POWER OUT connector of the 1st unit to the POWER IN connector
of the second unit, etc.
