48
13
A
B
2
1
2
1
B4.3.3 Adjusting the scissors arm balance
• Adjusting the first arm
If the first arm also needs to be adjusted:
Adjusting the friction (for small corrections - picture A)
1 Close the arm scissors arm; remove the plastic co-ordinator covers. This must be done
carefully to avoid breaking the covers.
2 Using a 2.5 mm hexagon wrench, loosen the dowel (
1
).
3 Using two 13 wrenches, adjust the frictioning mechanism by rotating one of the
wrenches ¼ of a turn each time.
4 When you have finished the adjustment, tighten the previously loosened dowel and
reassemble the plastic covers
Adjusting the spring (picture B)
If adjustment of the friction is not enough, you can adjust the spring to optimize the
balance:
1. Put the arm in a horizontal position; remove the plastic coordinator covers. This must
be done carefully to avoid breaking the covers.
2. Insert a 6 mm allen wrench (about 200mm long – contained in the kit P/N
E6661209900). This wrench must rotate clockwise if the arm tends to go down
compared to the release position; anticlockwise if it tends to go up.
3. When you have finished the adjustment, reposition the plastic covers
Summary of Contents for IMAGE-VET 70 ACP
Page 2: ......
Page 16: ...14 Typical Wall Mounting Typical Mobile Mounting ...
