47
A
B
1
1
2
2
13
13
B4.3.3 Adjusting the scissors arm balance
• Adjusting the second arm
Proceed as follows to adjust the scissors arm:
Adjusting the friction (for small corrections - picture A)
1. Put the arm in a horizontal position; remove the plastic coordinator covers. This must
be done carefully to avoid breaking the covers.
2. Using a 2.5 mm allen wrench, loosen the dowel (1).
3. Using two 13 wrenches, adjust the frictioning mechanism by
rotating one of the wrenches ¼ of a turn each time.
4. When you have finished the adjustment, tighten the
previously loosened dowel and reassemble the plastic covers.
Adjusting the spring (picture B)
If adjustment of the friction is not enough, you can adjust the spring to optimize the
balance:
1 Put the arm in a horizontal position; remove the plastic coordinator covers. This must
be done carefully to avoid breaking the covers.
2 Insert a 6 mm allen wrench (about 200mm long –contained in the kit P/N
6661209900). This wrench must rotate clockwise if the arm tends to go down
compared to the release position; anticlockwise if it tends to go up.
3 When you have finished the adjustment, reposition the plastic covers.
Summary of Contents for IMAGE-VET 70 ACP
Page 2: ......
Page 16: ...14 Typical Wall Mounting Typical Mobile Mounting ...
