Afinia Label
16
| Using the Printer
Loading the Printer
The Afinia Label L502 Label Printer requires a 3” ID core with the labels wound face out.
NOTE: Steps 2 through 7 apply to the L502 model only.
1.
Cut a clean leading edge on media being loaded
a.
No partially peeled labels
b.
No folded edges
F502 – Skip to step 7
2.
Loosen the knob on the Stock Mandrel and
remove the adjustable guide plate
3.
Slide the roll onto the Mandrel
against the fixed guide
plate, label side up
4.
Pull end of label stock
until the end of stock is
even with the front of the
cover
5.
Slide the adjustable guide
plate back onto the Mandrel
against the stock
6.
Retighten the Mandrel knob until the Mandrel
holds the core in place
7.
Using the black handle, slide the label guide out to at least the width of the stock
8.
With the printer on, feed the
stock into the input slot
a.
Stock should be as far
towards the fixed core
holder side as possible
9.
Feed until the printer advances the stock
10.
When the stock starts loading, adjust the label guide
so it is against the edge of the stock
Unloading Media
Press the
Unload
button to roll media back to
the rear of the printer
Any printed labels in the printer will be cut
before unloading
Mandrel knob
Label Guide