Afag CS 16/30, Manual, Page: 9 / 49

8 CS 16 - CS 20 - OI-vers. 5.3 gb. 20190312
2.1.3 Tightening torques for bolts
The bolts to be used for assembly must at least satisfy the following conditions:
Standard: VDI 2230
Strength: class 8.8
Surface: galvanized blue, oiled or greased
Thread Tightening torques
M3 1.1 … 1.4 Nm
M4 2.6 … 3.3 Nm
M5 5.2 … 6.5 Nm
M6 9,0 ... 11.3 Nm
M8 21.6 … 27.3 Nm
This is a partly complete machine
Installation of the CS modules into a system
The series of the CS modules is used for the CS movement of rigidly mounted loads in non-explosion
hazardous ambient and operating conditions that are specified for these modules, see Technical Data Sheet in
the actual Handling catalogue. The rotary modules can be mounted in any possible position.
NOTE
This Montage Instructions should be read carefully before carrying out any activity on or
with the
CS module
. The CS module may only be deployed in accordance with the
intended use.
Safety instructions
NOTE
Modifications to the CS module that are not described in this Montage Instructions or have
not been approved in writing by the company Afag Automation AG are not permitted. In
case of improper changes or assembly, installation, operation, maintenance or repairs, Afag
Automation AG rejects all liability.