AES 3100S-PKG, Installation, Operation, And Programming Manual, Page: 8 / 30

AES SOLAR Subscriber 8
AES P/N 40-3100S Rev. 3, 3/14/2023
3. Pre-Installation
3.1
EQUIPMENT LIST
The following materials are available out of the box:
•
AES Solar Subscriber 1 ea. AES P/N 3100S
•
18 Ah Gel Cell Battery 1 ea. AES P/N 81810
•
Subscriber Mounting Bracket 1 ea. AES P/N 30-3100-MB
•
Water proofing tape 1 ea. AES P/N 56-7701
•
Coax, 10 ft. 1 ea. AES P/N 13-0345-10
•
Antenna 1 ea. AES P/N 7264-PA
•
Antenna mount bracket 1 ea. AES P/N 52-0057
•
Quick Start Guide 1 ea. AES P/N 40-3100-QSG
•
Solar Panel 1 ea. AES P/N 65-3100-SP
3.2
REQUIREMENTS
Environmental Requirements
Select an installation location that meets the Environmental Specifications described in the
Technical Specifications
section.
Exposing the subscriber to temperatures below
–
13°F (
–
20°C) or above 158°F (70°C) can cause unexpected operation
of the subscriber electronics.
All the enclosure access points into the enclosure must be adequately sealed against water infiltration.
4. Installation
WARNING! Do NOT install the subscriber unit during a lightning storm or excessive wind conditions.
Mounting the Enclosure
Important! Solar exposure is critical to operation and sun tilt and location during solar exposure must
be considered.
Mounting location depends on customer application. Customer must consider the suitability
for the application the subscriber will be used for.
Weather Proofing Steps
Important! Use AES supplied water resistant tape and grease to prevent water entering the enclosure.
Apply this at each of the cable entries into the enclosure.