AES SOLAR Subscriber
6
AES P/N 40-3100S Rev. 3, 3/14/2023
1.
Safety Considerations
WARNING!
Subscriber antenna or other cables that come in contact with electrical power
lines may result in
DEATH
or
SERIOUS INJURY
.
WARNING!
Do
NOT
install the subscriber unit during a lightning storm.
•
Equipment must be installed in accordance with National Electric Code, NFPA 70, local building codes, and
any specific requirements of the Authority Having Jurisdiction (AHJ).
•
Ground the antenna, the SOLAR subscriber enclosure, and any surge protector devices to help dissipate surges
away from equipment and personnel. Antenna grounding and surge protectors are for your safety and the
safety of your equipment.
•
Periodically test the system for proper operation.
AES assumes no responsibility for the equipment’s
failure to operate. AES's sole responsibility is to repair or replace any AES device found to be defective during
the warranty period.
•
Avoid dropping or exposing the unit to physical impact that could damage the enclosure or internal
components.
2.
Technical Specifications
Requirements
Solar panel (supplied with unit)
•
Min. 50W capacity 18V output
•
Must select “SOLAR” power option in GUI setup
12 V DC from Rechargeable Backup Battery
in Enclosure
•
Minimum 18 Ah size
•
Must be SLA (gel cell) battery – due to temperature and
charge controller limitation
Operating Temperature:
–
13F to 185°F (
–
20°C to 70°C)
Relative Humidity: Non-condensing
Dimensions:
13.78 in. H × 13.78 W × 5.97 D (Inches)
Weight: 20 pounds with battery
Enclosure Material: Molded fiberglass reinforced polycarbonate, NEMA 4x style
Finish Color: Gray
•
Alarm Signal Inputs:
4 Zone Input – four each EOL resistor type – All inputs supervised with trouble and restore
Outputs
•
Relay Outputs, 4 ea.
•
15 A @ 120 VAC
•
10 A @ 250 VAC
Power Supply
Environmental Specifications
Mechanical Specifications
Inputs
Reporting