37
Throttle Servo and Choke Installation
1. Gather the left and right plywood throttle servo
mounting trays, the throttle servo, and pushrod
parts as shown below. Due to the wide range of
engine and throttle hook up choices. Throttle
linkage hardware has not been included. The
following steps are recommendations.
2.
Use a 1/4 bit to drill a pushrod exit hole in the
firewall in line with the engine carburetor
throttle arm.
3.
Attach the 2-56 ball link to the throttle push-
rod and secure to the carburetor throttle arm
with a 2-56 bolt and nylon lock nut.
4.
The throttle servo is mounted on the side of
the fuse that aligns with the engine carburetor
throttle arm. Insert the throttle servo into the
appropriate throttle servo mounting tray with
the output arm forward. Insert the throttle
pushrod into the servo arm easy link and dry
fit inside the fuse. Align the servo tray so
there is no binding on the throttle pushrod.
