72
21. Dry fit template and check to see if the template
lines up correctly. It may be necessary to make
small adjustments to the cut out at this time.
22. Once satisfied with fit. Align template with the
center mark on alignment tape previously ap-
plied and fit flush with rear of cowl. Tape tem-
plate to bottom of cowling and mark cut lines
with removable marker.
Note:
Take care and test painted areas prior to
using any type of paint remover, rubbing
alcohols or cleaners to remove any pen lines.
23. Remove the template and use a rotary cutting
tool and sanding drum to cut out the opening in
the cowl.
24. Reinstall the cowl to check the fit of the cylinder
head and muffler.
Note:
Be sure that the cylinder head and muffler
will not rub against the cowl. Make
adjustments as necessary.
Note:
We have found this to be adequate cooling for
the DA 50. Depending on your engine’s oper-
ating temperature, you may need to allow for
more exit air for your engine to run at its rec-
ommended operating temperature.
Always check the operating temperature of
your engine to prevent any damage from
occurring. Aeroworks is not responsible for
damages incurred from improper engine
cooling.
